Small
endmill or bit holder - Double Angle Collet Tool Holder |
|
| Description Holder | Made of Stainless steal, Made in the USA. Design uses 32 pitch threads. Holds type DA 300 double angle collets. You should be able to buy collets locally. Great for small engraving and detailed cutting in 3D parts in wood, plastic and other material. This collet holder has a run out of +-.0005 to .002 inch at a length of the cutter extruded out .50 inches from the collet. DA collets can not take too much load so this is not recommended for cutting aluminum. But I have not tested the system on aluminum. |
| Application | Hold small bits or endmill that normally can not be held by typical router collets. |
| Condition | New Stainless Steal |
| Threads | 32 per inch |
| Brand | K2 made in USA |
| Model Number | DA300-K1 |
| Wrench | 5mm |
| Min/Max Collet Size | 1/32 to 1/4 inch |
| Shank (holding diameter on shaft) | 0.50 inch |
| Material | Stainless Steal |
| Length of Shank | 1 inch |
| These are the typically collet size available out there. List is for information purposes only. You should check your local collet sellers to see what is available. | 1/32" 1/16" 3/32" 1/8" 5/32" 3/16" 7/32" 1/4" |
| Warranty | Returnable within 15 days |
| Site | www.K2cnc.com |
